Filter
Top Products
Technobeam
®
User Manual DMX Protocols A-7
1
- “Slow” modulation is 4.25 times/sec and “fast” modulation is 255 times/sec, at 50% duty cycle.
2
- You must set the Shutter channel to zero before accessing the Control channel.
3
- When set to Safe, the control channel has no effect if the shutter is closed.
4
- Hold the Control channel at this value for at least one second. Homing the fixture in this way
does not change the state of the lamp (if the lamp was off, it stays off; if the lamp was on, it stays
on).
5
- Hold the Control channel at this value for at least one second. If the lamp is currently off, turning
the lamp on in this way causes the fixture to home. (If the lamp was already on, the command has
no effect.)
6
- Hold the Control channel at this value for at least one second. The lamp will also turn on
whenever you power up the fixture on a link when there is a controller present and it is sending data
commands.
Technobeam-i™ Protocol
Table 2 lists the 18 Technobeam-i constructs and their corresponding DMX controller
values. If you have a numeric-type controller, use the Value Decimal (dec.) column. If
you have a fader-type controller, use the Value Percentage (%) column. If your controller
allows you to program hex values, use the Value (hex) column. The values in the Value
17 n/a
Laser Aiming Device (LAD)
LAD off 0 - 7
120 - 127
0 - 3
47 - 49
00 - 07h
78h - 7Fh
LAD modulate slow to
fast
1
128 - 247 50 - 96 80h - F7h
LAD on (continuous) 248 - 255 97 - 100 F8h - FFh
Macros Macro 1—28 (see Table A-4 on page A-15)
18 14
Control
2
Safe
3
0 - 7 0 - 3 00h - 07h
Display off 24 - 26 9 - 10 18h - 1Ah
Display dim 32 - 34 13 20h - 22h
Display bright 40 - 42 16 28h - 2Ah
Home
4
64 - 66 25 - 26 40h - 42h
Lamp on
5
80 - 82 31 - 32 50h - 52h
Lamp off
6
96 - 98 38 60h - 62h
Shutdown 128 - 130 50 - 51 80h - 82h
Table A-1. Technobeam DMX Protocol
Ch. (F) Ch. (R) Construct Parameter
Value
(dec.)
Value
(%)
Value
(hex)