Filter
Top Products
ProSecure Unified Threat Management UTM10 or UTM25 Reference Manual
1-6 Introduction
v1.0, September 2009
Extensive Protocol Support
The UTM supports the Transmission Control Protocol/Internet Protocol (TCP/IP) and Routing
Information Protocol
(RIP). For further information about TCP/IP, see “Internet Configuration
Requirements” on page B-3. The UTM provides the following protocol support:
• IP address sharing by NAT. The UTM allows many networked PCs to share an Internet
account using only a single IP address, which might be statically or dynamically assigned by
your Internet service provider (ISP). This technique, known as NAT, allows the use of an
inexpensive single-user ISP account.
• Automatic configuration of attached PCs by DHCP. The UTM dynamically assigns
network configuration information, including IP, gateway, and domain name server (DNS)
addresses, to attached PCs on the LAN using the Dynamic Host Configuration Protocol
(DHCP). This feature greatly simplifies configuration of PCs on your local network.
• DNS proxy. When DHCP is enabled and no DNS addresses are specified, the firewall
provides its own address as a DNS server to the attached PCs. The firewall obtains actual DNS
addresses from the ISP during connection setup and forwards DNS requests from the LAN.
• PPP over Ethernet (PPPoE). PPPoE is a protocol for connecting remote hosts to the Internet
over a DSL connection by simulating a dial-up connection.
• Quality of Service (QoS). The UTM supports QoS, including traffic prioritization and traffic
classification with Type Of Service (ToS) and Differentiated Services Code Point (DSCP)
marking.
Easy Installation and Management
You can install, configure, and operate the UTM within minutes after connecting it to the network.
The following features simplify installation and management tasks:
• Browser-based management. Browser-based configuration allows you to easily configure
your firewall from almost any type of personal computer, such as Windows, Macintosh, or
Linux. A user-friendly Setup Wizard is provided and online help documentation is built into
the browser-based Web Management Interface.
• Auto detection of ISP. The UTM automatically senses the type of Internet connection, asking
you only for the information required for your type of ISP account.
• IPsec VPN Wizard. The UTM includes the NETGEAR IPSec VPN Wizard to easily
configure IPsec VPN tunnels according to the recommendations of the Virtual Private
Network Consortium (VPNC) to ensure the IPsec VPN tunnels are interoperable with other
VPNC-compliant VPN routers and clients.