Filter
Top Products
ProSecure Unified Threat Management UTM10 or UTM25 Reference Manual
1-12 Introduction
v1.0, September 2009
Rear Panel
The rear panel of the UTM includes a cable lock receptacle, a console port, a reset button, and an
AC power connection.
Viewed from left to right, the rear panel contains the following components:
1. Cable security lock receptacle.
2. Console port. Port for connecting to an optional console terminal. The ports has a DB9 male
connector. The default baud rate is 9600 K. The pinouts are: (2) Tx, (3) Rx, (5) and (7) Gnd.
3. Factory default Reset button. Using a sharp object, press and hold this button for about eight
seconds until the front panel Test light flashes to reset the UTM to factory default settings. All
configuration settings are lost and the default password is restored.
4. AC power receptacle. Universal AC input (100-240 VAC, 50-60 Hz).
Bottom Panel With Product Label
The product label on the bottom of the UTM’s enclosure displays factory default, regulatory
compliance, and other information (see Figure 1-4 and Figure 1-5 on page 1-13).
Figure 1-3
Security lock
receptacle
Console port
Reset button
AC power
receptacle