Filter
Top Products
ProSecure Unified Threat Management UTM10 or UTM25 Reference Manual
System Logs and Error Messages C-7
v1.0, September 2009
PPP Logs
This section describes the WAN PPP connection logs. The PPP type can be configured through the
Web Management Interface (see “Manually Configuring the Internet Connection” on page 3-5).
• PPPoE Idle-Timeout Logs
Table C-10. System Logs: WAN Status, PPPoE Idle-Timeout
Message 1
Message 2
Message 3
Message 4
Message 5
Message 6
Message 7
Message 8
Message 9
Message 10
Message 11
Nov 29 13:12:46 [UTM] [pppd] Starting connection
Nov 29 13:12:49 [UTM] [pppd] Remote message: Success
Nov 29 13:12:49 [UTM] [pppd] PAP authentication succeeded
Nov 29 13:12:49 [UTM] [pppd] local IP address 50.0.0.62
Nov 29 13:12:49 [UTM] [pppd] remote IP address 50.0.0.1
Nov 29 13:12:49 [UTM] [pppd] primary DNS address 202.153.32.3
Nov 29 13:12:49 [UTM] [pppd] secondary DNS address 202.153.32.3
Nov 29 11:29:26 [UTM] [pppd] Terminating connection due to lack of activity.
Nov 29 11:29:28 [UTM] [pppd] Connect time 8.2 minutes.
Nov 29 11:29:28 [UTM] [pppd] Sent 1408 bytes, received 0 bytes.
Nov 29 11:29:29 [UTM] [pppd] Connection terminated.
Explanation Message 1: PPPoE connection establishment started.
Message 2: Message from PPPoE server for correct login
Message 3: Authentication for PPP succeeded.
Message 4: Local IP address assigned by the server.
Message 5: Server side IP address.
Message 6: primary DNS configured in WAN status page.
Message 7: secondary DNS configured in WAN status page.
Message 8: The PPP link has transitioned to idle mode. This event occurs if
there is no traffic from the LAN network.
Message 9: The time in minutes for which the link has been up.
Message 10: Data sent and received at the LAN side during the link was up.
Message 11: PPP connection terminated after idle timeout
Recommended Action To reconnect during idle mode, initiate traffic from the LAN side.