Filter
Top Products
ProSecure Unified Threat Management UTM10 or UTM25 Reference Manual
2-14 Using the Setup Wizard to Provision the UTM in Your Network
v1.0, September 2009
Setup Wizard Step 3 of 10: System Date and Time
Enter the settings as explained in Table 2-3 on page 2-15, then click Next to go the following
screen.
Use These DNS
Servers
If your ISP has assigned DNS addresses, select the Use these DNS Servers radio
button. Ensure that you fill in valid DNS server IP addresses in the fields. Incorrect
DNS entries might cause connectivity issues.
Primary DNS Server The IP address of the primary DNS server.
Secondary DNS Serve The IP address of the secondary DNS server.
Figure 2-9
Note: After you have completed the steps in the Setup Wizard, you can make changes to
the date and time by selecting Administration > System Date & Time. For more
information about these settings, see “Configuring Date and Time Service” on
page 10-24.
Table 2-2. Setup Wizard Step 2: WAN Settings (continued)
Setting Description (or Subfield and Description)