Filter
Top Products
ProSecure Unified Threat Management UTM10 or UTM25 Reference Manual
Using the Setup Wizard to Provision the UTM in Your Network 2-23
v1.0, September 2009
Setup Wizard Step 8 of 10: Administrator Email Notification
Settings
Enter the settings as explained in Table 2-8, then click Next to go the following screen.
Figure 2-14
Note: After you have completed the steps in the Setup Wizard, you can make changes to
the administrator email notification settings by selecting Network Config > Email
Notification. For more information about these settings, see
“Configuring the E-mail Notification Server” on page 11-5.
Table 2-8. Setup Wizard Step 8: Administrator Email Notification Settings
Setting Description (or Subfield and Description)
Administrator Email Notification Settings
Show as mail sender A descriptive name of the sender for e-mail identification purposes. For
example, enter UTM_Notifications@netgear.com.
SMTP server The IP address and port number or Internet name and port number of your
ISP’s outgoing e-mail SMTP server. The default port number is 25.
Note: If you leave this field blank, the UTM cannot send e-mail notifications.