Filter
Top Products
X-STREAM
4-5
Instruction Manual
HASAxE-IM-HS
07/2006
Emerson Process Management GmbH & Co. OHG
4 Installation
4-3 Electrical Connections
4-3 Installation - Electrical Connections
ELECTRICAL SHOCK HAZARD!
Installation and connecting power and signal cables are subject to qualified
personnel only taking into account all applicable standards and legislative
requirements!
Failure to follow may cause warranty invalidation, property damage and/or
personal injury or death!
Installation of these instruments is subject to qualified personnel only,
familiar with the resulting potential risks! Instruments providing screw
terminals for electrical connections may require working near live part!
X-STREAM gas analyzers do not provide a power switch!
For X-STREAM F analyzers a power switch or circuit breaker (complying
with IEC 60947-1/-3) has to be provided in the building installation. This switch
has to be installed near by analyzer, must be easily operator accessible and
has to be assigned as disconnector for the analyzer.
Disconnect instruments with screw terminals from power when working at
power terminals (pull power plug or operate power switch/ circuit breaker in
building installation)!
The analyzers provide a protective earth terminal. To prevent electrical shock
hazards the instruments must be connected to a protective earth. Therefore
the instruments must be connected to power by using a three wire power
cable with earth conductor!
Any interruption of the earth connector inside or outside the instrument or
disconnecting the earth terminal may cause potential electrical shock
hazzard!
The analyzers do not provide a power switch and are operable when connec-
ted to power.
Installation instructions for
X-STREAM GP, X-STREAM GPS Page 4-6
X-STREAM F Page 4-20
Hints on wiring signal inputs and outputs Page 4-28