Filter
Top Products
Using Intelligent Input Terminals
Operations
and Monitoring
4–14
While using the multi-speed capability, you can monitor the output frequency with monitor
function D001 during each segment of a multi-speed operation.
There are two ways to program the speeds into the registers A020 to A035:
1. Standard keypad programming:
a. Select each parameter A020 to A035.
b. Press the key to view the parameter value.
c. Use the and keys to edit the value.
d. Use the key to save the data to memory.
2. Programming using the CF switches:
a. Turn the Run command OFF (Stop Mode).
b. Turn inputs ON to select desired Multi-speed. Display the value of F001 on the digital
operator.
c. Set the desired output frequency by pressing the and keys.
d. Press the key once to store the set frequency. When this occurs, F001 indicates the
output frequency of the selected Multi-speed.
e. Press the key once to confirm that the indication is the same as the set frequency.
f. Repeat operations in 2. a) to 2. e) to set the frequency of other Multi-speeds. It can be set
also by parameters A020 to A035 in the first procedure 1. a) to 1. d).
Opt.
Code
Symbol Function Name
Input
State
Description
02 CF1 Binary speed select,
Bit 0 (LSB)
ON Bit 0, logical 1
OFF Bit 0, logical 0
03 CF2 Binary speed select,
Bit 1
ON Bit 1, logical 1
OFF Bit 1, logical 0
04 CF3 Binary speed binary
select, Bit 2
ON Bit 2, logical 1
OFF Bit 2, logical 0
05 CF4 Binary speed select,
Bit 3 (MSB)
ON Bit 3, logical 1
OFF Bit 3, logical 0
Valid for
inputs:
C001, C002, C003, C004,
C005, C006, C007, C008
Required
settings:
F001, A020 to A035
A019=00
Notes:
• When programming the multi-speed settings,
be sure to press the Store key each time and
then set the next multi-speed setting. Note
that when the Store key is not pressed, no
data will be set.
• When a multi-speed setting more than
50Hz(60Hz) is to be set, it is necessary to
program the maximum frequency A004 high
enough to allow that speed.
5 3 1
7 6 4 2
8
FW
TH
PLC
CM1
P24
CM1
Example: (Some CF inputs require input
configuration; some are default inputs—
see page 3–47
. Jumper position shown is
for –xFU/-xFR models; for –xFE models,
see page 4–12
.)
See I/O specs on page 4–9
.
CF1CF2
CF3
CF4
(LSB) (MSB)
FUNC.
1
2
STR
1
2
STR
FUNC.