Filter
Top Products
SJ300 Inverter
Appendix C
C–11
C031 Terminal [11] active state 00 00 00
C032 Terminal [12] active state 00 00 00
C033 Terminal [13] active state 00 00 00
C034 Terminal [14] active state 00 00 00
C035 Terminal [15] active state 00 00 00
C036 Alarm relay active state 01 01 01
C040 Overload signal output mode 01 01 01
C041 Overload level setting
Rated current
for each
inverter
Rated current
for each
inverter
Rated current
for each
inverter
C042 Frequency arrival setting for accel. 0.00 0.00 0.00
C043 Arrival frequency setting for decel. 0.00 0.00 0.00
C044 PID deviation level setting 3.0 3.0 3.0
C045 Frequency arrival setting for
acceleration (2)
0.00 0.00 0.00
C046 Frequency arrival setting for
deceleration (2)
0.00 0.00 0.00
C055 Over-torque (forward-driving) level
setting
100. 100. 100.
C056 Over-torque (reverse regenerating)
level setting
100. 100. 100.
C057 Over-torque (reverse driving) level
setting
100. 100. 100.
C058 Over-torque (forward regenerating)
level setting
100. 100. 100.
C061 Electronic thermal warning level
setting
80. 80. 80.
C062 Alarm code output 00 00 00
C063 Zero speed detection level 0.00 0.00 0.00
C070 Data command method 02 02 02
C071 Communication speed selection 04 04 04
C072 Node allocation 1. 1. 1.
C073 Communication data length selec-
tion
777
C074 Communication parity selection 00 00 00
C075 Communication stop bit selection 1 1 1
C078 Communication wait time 0. 0. 0.
C081 [O] input span calibration Factory set Factory set Factory set
“C” Group Parameters Default Setting
User
Setting
Func.
Code
Name
-FE (Europe) -FU (USA) -FR (Japan)