Filter
Top Products
Using the Front Panel Keypad
Inverter Mounting
and Installation
2–26
Selecting
Functions and
Editing Parame-
ters
In order to run the motor for the powerup test, this section will show how to:
• select the inverter’s maximum output frequency to the motor
• select the keypad potentiometer as the source of motor speed command
• select the keypad as the source of the RUN command
• set the number of poles for the motor
• enable the RUN command
The following series of programming tables are designed for successive use. Each table uses
the previous table’s final state as the starting point. Therefore, start with the first and continue
programming until the last one. If you get lost or concerned that some of the other parameters
settings may be incorrect, refer to “
Restoring Factory Default Settings” on page 6–9.
CAUTION: If you operate a motor at a frequency higher than the inverter standard default
setting (50Hz/60Hz), be sure to check the motor and machine specifications with the respective
manufacturer. Only operate the motor at elevated frequencies after getting their approval.
Otherwise, there is the danger of equipment damage.
Setting the Motor Base Frequency -The motor is designed to operate at a specific AC
frequency. Most commercial motors are designed for 50/60 Hz operation. First, check the
motor specifications. Then follow the steps in the table below to verify the setting or correct for
your motor. DO NOT set it for greater than 50/60 Hz unless the motor manufacturer specifi-
cally approves operation at the higher frequency.
TIP: If you need to scroll through a function or parameter list, press and hold the or
key to auto-increment through the list.
Action Display Func./Parameter
Press the
key.
Monitor functions
Press the or keys until ->
“A” Group selected
Press the key.
First “A” parameter
Press the key twice.
Base frequency setting
Press the key.
or
Default value for base frequency
US = 60 Hz, Europe = 50 Hz
Press the or key as needed.
Set to your motor specs (your
display may be different)
Press the key.
Stores parameter, returns to “A”
Group list
FUNC
d 001
1
2
A–––
FUNC
A001
1
A003
FUNC
60
50
1
2
60
STR
A003
1
2