Filter
Top Products
ACU-RITE 3500i 149
7. 2 C a n n e d C y c l e s
Counterbore Drill Cycle
Counterbore drill cycle generally used for counterboring. It feeds
from the R-plane to Z depth, dwells for specified time, then rapids
to the return point.
G-code format: G82
Peck Drill Cycle
The peck drilling cycle is generally used for peck drilling relatively
shallow holes. It feeds from the R-plane to the first peck depth
(calculated so that all pecks are equal and do not exceed the
maximum peck distance programmed in I word). Then rapid retracts
to R-plane (to clear chip), rapids down to previous depth less .02",
and continues this loop until it reaches the final hole depth. It then
rapid retracts to the P dimension.
G-code format: G83
Field Code Description
ZDepth Z Absolute hole depth. (Required)
StartHgt R Initial Z start point, in rapid. (Required)
ReturnHgt P Z return point after hole depth, in rapid.
Dwell D Dwell time (in seconds). (Required)
Feedrate F Feedrate
Field Code Description
ZDepth Z Absolute hole depth. (Required)
StartHgt R Initial Z start point, in rapid. (Required)
ReturnHgt P Z return point after hole depth, in rapid.
Peck I Maximum peck distance (positive
dimension). (Required)
Feedrate F Feedrate