Filter
Top Products
ACU-RITE 3500i 303
10.1 CAM Programming
Pocket Finish Cycles
The Pocket Finish Cycles tool path is used to generate a bottom and/
or side pocket finish cycle. A Pocket Cycle tool path is required prior
to the pocket finish cycle. The Pocket Finish cycle uses the shape and
islands specified in the previous Pocket cycle.
Bottom tab:
Bottom Finish: Check this box to use the bottom finish parameters
in the finish cycle.
Tool: Enter the tool number to use for the cycle.
Ramp Feed: Enter the ramp feed. Automatically calculated if tool
being used is defined in the Tool Table.
Ramp Feed = (Rough Feed + Finish Feed) ÷ 2.
Finish Feed: Enter the XY axes finish feed rate.
Coolant: Choose None, On or Off. See "Coolant" on page 290.
Spindle Dir: Choose Forward, Reverse, Off or None. See "Spindle
Direction" on page 290.
Spindle Speed: Enter the spindle speed.
Finish Dir: Direction of the finish pass (CW or CCW).
Side tab:
Side Finish: Check this box to use the side finish parameters in the
finish cycle.
Z Depth: Enter the absolute depth of the finished pocket.
Depth Cut: Enter the Z-axis increment used for each pass.
Side Stock: Enter that amount of side stock to be left for additional
finish operations if required.
Tool: Enter the tool number to use for the cycle.
Ramp Feed: Enter the ramp feed. Automatically calculated if tool
being used is defined in the Tool Table.
Ramp Feed = (Rough Feed + Finish Feed) ÷ 2.
Finish Feed: Enter the XY axes finish feed rate.
Coolant: Choose None, On or Off. See "Coolant" on page 290.
Spindle Dir: Choose Forward, Reverse, Off or None. See "Spindle
Direction" on page 290.
Spindle Speed: Enter the spindle speed.
Finish Dir: Direction of the finish pass (CW or CCW).
Comment Tab:
Add a comment if needed that will be placed in program. See
sample "Comment tab:" on page 298.