Filter
Top Products
164 7 Programming: Canned Cycles, sub-programs
7.2 Canned Cycles
Tool Length Offset is set the same as with any other tool or
operation. A tool diameter also has to be set in the tool table, as tool
diameter compensation is built into this cycle (tool diameter
compensation is not allowed during the use of this cycle).
If X (XCenter) and Y (YCenter) are not programmed, position tool
center of the thread before the Thread Mill Cycle line:
X and Y rapids to the starting position of the thread.
Z rapids to the safe height specified in P (ZSafePosn).
The Z-axis feeds down to the start cut position H (ZStart). This
could be above or below the Z position specified in the Z (ZFinish)
finish position.
Depending on what is in the R (ArcInRad) parameter the tool arcs
into the first cut position.
Spiral up or down, depending on the difference between "Z" and
"H" and go counterclockwise or clockwise depending if D
(MajorDia) is plus or minus.
Then arc-out and feed to the thread center for inside threads or a
safe distance away from the thread for outside threads depending
on the value in R (ArcInRad).
Then feed back to the "H" height.
Then feed X and Y to the next depth of cut. The depth of each
roughing pass is the thread depth specified in the C (ThdDepth)
parameter minus the stock amount specified in the S (StockAmt)
parameter, divided by the number of roughing passes specified in
the E (Passes) parameter.
The cycle repeats this process until the final finish pass.
It then cuts the thread at the full thread major diameter.
With a cutter diameter of 0.625, this program cuts a 1-8 inside
thread at X0 Y0. The tool spirals down the thread pitch of 8 threads
per inch, finishing at a depth of -1. The starting height is 0.1, the safe
rapid Z (ZFinish) height is 0.5, the major thread diameter is 1”, and
depth of thread is 0.0625. The arc-in radius is 0.1 and the stock
amount for the finish pass is 0.002. The rough feedrate is 20.0 and
the finish feedrate is 5.0.
G-code format: G181
If you would like all non-cutting positioning moves to be
rapid, set E (Passes) to a negative number. The idea is to
initially set "E" as a positive number and after proving out
the program, change "E" to a negative number for faster
production. If you only need one pass to size and you want
the positioning moves to be rapid, set "E" to -1.