Filter
Top Products
ACU-RITE 3500i 297
10.1 CAM Programming
Setup tab:
Tool: Once the tool has been entered into the tool table, its tool
number can be entered here.
Feed: The tool feed rate is entered here. This is automatically
calculated if tool being used is defined in the Tool Table.
Coolant: Choose None, On or Off. See "Coolant" on page 290.
Spindle Dir: Choose Forward, Reverse, Off or None. See "Spindle
Direction" on page 290.
Spindle Speed: Specify spindle speed. See "Spindle Speed" on page
290.
Bolt Hole tab:
The Bolt Hole tab must have the appropriate data filled in to use the
Bolt Hole option in the Drill Location selection.
Diameter: The diameter of bolt hole circle pattern can be entered
here.
# Holes: The number of holes in the pattern are entered in this field.
Start Angle: The starting angle of the pattern is entered in this field.
Path: Choose the machine movement required: Linear, or Radial.
X Center: Location of the center of rotation in the X axis.
Y Center: Location of the center of rotation in the Y-axis.
End Angle: The end angle of the last hole.
Index Angle: This is the angle to rotate the Polar Coordinate
System by.