Filter
Top Products
306 10 CAM: Programming
10.1 CAM Programming
Setup tab:
Tool: Enter the tool number to use for the cycle.
Feed: Enter the feed rate used while engraving.
Coolant: Choose None, On or Off. See "Coolant" on page 290.
Spindle Dir: Choose Forward, Reverse, Off or None. See "Spindle
Direction" on page 290.
Spindle Speed: Enter the spindle speed.
Comment tab:
Add a comment if needed that will be placed in program. See
sample "Comment tab:" on page 298.
Program Directive
The Program Directive Tool enables you to add any programming
code, notes or comments.
Adding a Program Directive
Select the Add Directive button.
Enter code or text into the Add Directive dialogue. Text requires a
“∗” before the text (for a comment).
Touch on the Use button to add the directive to the tool path
sequence.