Filter
Top Products
Solaris SFS Driver User Manual Page 165
Migrating Manually
To migrate manually:
1. Back up all data and system disks.
2. Note current lpfc target and LUN information contained in the following files:
• /etc/vfstab
• /kernel/drv/lpfc.conf
• /kernel/drv/sd.conf
Persistent binding of the lpfc driver's targets is recommended before performing migration.
3. Using Emulex lputil or HBAnyware utilities for lpfc (bundled as part of the driver kit available at
http://www.emulex.com/ts/downloads/solpci/sol.html):
• Update the FCode in all adapters to the latest version.
• Verify that FCode is enabled.
4. Install the required SFS version or patch, as described in
Installing or Updating the Utilities Package
Manually
on page 9. SFS will not recognize any existing adapter, as your existing HBAs remain
lpfc-attached. Make sure the SFS version and driver patch support the adapters that are to be
used.
5. Install the emlxdrv/emlxadm utility package.
6. Start emlxdrv and enter the command set_emlxs_all. This changes the bindings of all
Emulex adapters from lpfc control to emlxs.
7. Reboot the system with the shutdown command.
8. Install any new Sun-branded or Emulex HBAs.
9. Boot to the ok prompt.
10. Issue the Emulex FCode set-sfs-boot command to change the Emulex HBA's device path
from lpfc to emlx. The change will not take effect until the system is reset.
Example:
{0} ok show-devs
.
.
.
/pci@8,600000/lpfc@2
.
.
.
{0} ok " /pci@8,600000/lpfc@2" select-dev
^
Space required
{0} ok set-sfs-boot
{0} ok unselect-dev
Repeat this step for all adapters in the system. Type reset-all, then boot the system to the
OS.