Filter
Top Products
Solaris SFS Driver User Manual Page 71
3. Select the Diagnostics tab and click Quick Test. The following message appears:
Figure 32: HBAnyware Utility, Quick Test Message
4. Click OK to run the test. The Quick Diagnostics Test message shows the PCI Loopback and
Internal Loopback test results.
Running a POST Test
The POST (Power On Self Test) is a firmware test normally performed on an HBA after a reset or restart.
The POST does not require any configuration to run.
To run the POST Test:
1. Start the HBAnyware utility.
2. From the discovery-tree, select the HBA on which you wish to run the POST Test.
3. Select the Diagnostics tab and click Power-on Self Test (POST). A warning dialog box appears.
Figure 33: HBAnyware Utility, POST Test Warning Window
4. Click OK. A POST Test window shows POST test information.
Using Beaconing
The beaconing feature enables you to force a specific HBA’s LEDs to blink in a particular sequence. The
blinking pattern acts as a beacon, making it easier to locate a specific HBA among racks of other HBAs.
When you enable beaconing, the two LEDs blink rapidly in unison for 24 seconds, after which the LEDs
report the HBA health status for 8 seconds. When the 8 seconds are up, the HBA returns to beaconing
mode. This cycle repeats indefinitely until you disable this feature or you reset the HBA.
To enable or disable beaconing:
1. Start the HBAnyware utility.
2. From the discovery-tree, select the HBA whose LEDs you wish to set.
3. Select the Diagnostics tab and click Beacon On or Beacon Off.
Note: The beaconing buttons are disabled if the selected HBA does not support
beaconing.