Filter
Top Products
Solaris SFS Driver User Manual Page 16
network-on Min:0 (Disables)
Max:1 (Enables)
Default:1
Description: Enables or
disables IP networking
support in the driver.
network-on Min:0 (Disables)
Max:1 (Enables)
Default:1
Description: Controls
whether lpfc provides IP
networking functionality over
FC. This variable is Boolean:
when zero, IP networking is
disabled: when non-zero, IP
networking is enabled.
The lpfc
parameter
enables or
disables FCIP on
the Emulex HBA.
num-iocbs Min:128
Max:1024
Default = 1024
Description: Sets the
number of iocb buffers to
allocate.
num-bufs Min:64
Max:128
Default = 128
Description: Specifies the
number of command buffers
to allocate. These buffers
are used for Fibre Channel
Extended Link Services
(ELS) and one for each FCP
command issued in SLI-2
mode. If you want to queue
lots of FCP commands to the
adapter, then you should
increase num-bufs for better
performance. These buffers
consume physical memory
and are also used by the
device driver to process loop
initialization and rediscovery
activities. Important: The
driver must always be
configured with at least
several dozen ELS
command buffers; Emulex
recommends at least 128.
num-nodes Min:2
Max:512
Default:512
Description: Number of FC
nodes (NPorts) the driver
will support.
N/A N/A
Table 1: Solaris SFS and lpfc Driver Parameter Cross-Reference (Continued)
Solaris SFS/
HBAnyware
Parameter
Solaris SFS/HBAnyware
Min/Max, Defaults and
Description
Related
lpfc
Parameter
lpfc Min/Max, Default and
Description
Comments