Filter
Top Products
Solaris SFS Driver User Manual Page 31
Sample response:
Set Driver Parameter log_verbose=3(g) for 10:00:00:00:c9:2e:51:2e
Parameters:
WWPN - The World Wide Port Name of the HBA whose Boot BIOS you want to modify. This HBA can be
either local or remote.
ctrlword - G = make change global, B = make change both permanent and global, N = make change
neither permanent nor global
param - The name of the parameter whose value you want to modify. You can only use the log_verbose,
use_adisc and _nodev_tmo parameters. Do not precede these commands with lpfc_. For example use
log_verbose not lpfc_log_verbose.
Value - The new value you want to assign to the parameter.
SetBootBios
Syntax: HBACMD SetBootBios <wwpn> <ctrlword>
Description: Enables or disables the Boot BIOS on the referenced HBA. To enable the Boot BIOS for
10:00:00:00:c9:2e:51:2e, type:
hbacmd setbootbios 10:00:00:00:c9:2e:51:2e E
Parameters:
WWPN - The World Wide Port Name of the HBA whose Boot BIOS you want to modify. This HBA can be
either local or remote.
ctrlword - E = enable the Boot BIOS, D = disable the Boot BIOS.
PciData
Syntax: HBACMD PciData <wwpn>
Description: Shows PCI configuration data for the HBA specified by the WWPN. To show PCI
configuration data for HBA 10:00:00:00:c9:2e:51:2e, type:
hbacmd pcidata 10:00:00:00:c9:2e:51:2e
Sample response:
Vendor ID: 0x10DF Device ID: 0xF0D5
Command: 0x0157 Status: 0x0230
Revision ID: 0x01 Prog If: 0x00
Subclass: 0x04 Base Class: 0x0C
Cache Line Size: 0x20 Latency Timer: 0xF8
Header Type: 0x00 Built In Self Test: 0x00
Base Address 0: 0xE0001004 Base Address 1: 0x00000000
Base Address 2: 0xE0000004 Base Address 3: 0x00000000
Base Address 4: 0x0000C001 Base Address 5: 0x00000000
CIS: 0x00000000 SubVendor ID: 0x10DF
SubSystem ID: 0xF0D5 ROM Base Address: 0x00000000
Interrupt Line: 0xFF Interrupt Pin: 0x01
Minimum Grant: 0xFF Maximum Latency: 0x00
Capabilities Ptr: 0x5C
Parameters:
WWPN - The World Wide Port Name of the HBA whose PCI configuration data you want to show.