Filter
Top Products
Solaris SFS Driver User Manual Page 17
pm-support 0 = Disables power
management support in the
driver.
1 = Enables power
management support in the
driver.
Default: 0
Description: Enable/Disable
power management support
in the driver
N/A N/A
topology 0 = loop, if it fails attempt pt-
to-pt
2 = pt-to-pt only
4 = loop only
6 = pt-to-pt, if it fails attempt
loop
Default: 0
Description: Link topology
for initializing the Fibre
Channel connection. Set pt-
to-pt if you want to run as an
N_Port. Set loop if you want
to run as an NL_Port.
topology 0x0 = loop, if it fails attempt
pt-to-pt
0x2 = pt-to-pt only
0x4 = loop only
0x6 = pt-to-pt, if it fails
attempt loop
Default: 0
Description: Controls the FC
topology expected by lpfc at
boot time. FC offers pt-to-pt,
fabric and arbitrated loop
topologies. To make the
adapter operate as an
N_Port, select pt-to-pt mode
(used for N_Port to F_Port
and N_Port to N_Port
connections). To make the
adapter operate as an
NL_Port, select loop mode
(used for private loop and
public loop topologies). The
driver will reject an attempt
to set the topology to a value
not in the above list. The
auto-topology settings 0 and
6 will not work unless the
adapter is using firmware
version 3.20 or higher.
The topology
parameter
controls the
protocol (not
physical)
topology
attempted by the
driver.
ub-bufs Min:40
Max:16320
Default:1000
Description: Sets the
number of unsolicited
buffers to be allocated.
N/A N/A
Table 1: Solaris SFS and lpfc Driver Parameter Cross-Reference (Continued)
Solaris SFS/
HBAnyware
Parameter
Solaris SFS/HBAnyware
Min/Max, Defaults and
Description
Related
lpfc
Parameter
lpfc Min/Max, Default and
Description
Comments