Filter
Top Products
Chapter 12-Network Services
12-18
Primary
Gatekeeper
IP Address or
Name
Enter either the gatekeeper’s host
name as registered in the DNS or IP
address.
Note:
When in
IPv4&IPv6
or in IPv6
mode, it is
easier to
use Names
instead of
IP
Addresses.
Alternate
Gatekeeper
IP Address or
Name
Enter the DNS host name or IP address
of the gatekeeper used as a fallback
gatekeeper used when the primary
gatekeeper is not functioning properly.
MCU Prefix in
Gatekeeper
Enter the number with which this Network Service
registers in the gatekeeper. This number is used by
H.323 endpoints as the first part of their dial-in string
when dialing the MCU.
When PathNavigator or SE200 is used, this prefix
automatically registers with the gatekeeper. When
another gatekeeper is used, this prefix must also be
defined in the gatekeeper.
Register as
Gateway
Select this check box if the RMX unit is to be seen as
a gateway, for example, when using a Cisco
gatekeeper.
Note: Do not select this check box when using
Polycom ReadiManager/CMA 5000 or a Radvision
gatekeeper.
Table 14 Default IP Service – Conferencing – Gatekeeper Parameters
(Continued)
Field Description