Filter
Top Products
Chapter 12-Network Services
12-40
2 For both the JITC_MODE and
SEPARATE_MANAGEMENT_NETWORK System Flags:
a Locate and double-click on the System Flag entry.
The Update Flag Name dialog box opens.
b In the New Value field, enter YES.
c Click the OK button to close the Update Flag Name dialog box.
3 Click the OK button to close the System Flags dialog box.
4 In the Reset Confirmation dialog box, click No.
5 In the RMX Management pane, click the IP Network Services ()
button.
6 In the IP Network Services list pane, right-click the Management
Network ( ) entry and select Properties.
7 Enter the Control Unit IP, Shelf Management IP and Subnet Mask
addresses in their respective field boxes.
8 Click the Routers tab.
9 Enter the Default Router IP Address.
10 Click the OK button.
A Reset Confirmation dialog box is displayed.
11 Connect a workstation that is connected to the Management LAN to
the RMX’s LAN 3 port.
12 In the Reset Confirmation dialog box, click Yes.
System restart may take up to five minutes.
If the JITC_MODE System Flag is set to YES and a valid TLS certificate is
installed, only secured connections are allowed:
• If the JITC_MODE System Flag is set to YES and the Management Network
Service has not yet been configured to be secured, an Active Alarm is
created and a message is displayed stating that Secured Communications
Mode must be enabled.
• If the JITC_MODE System Flag is set to YES and a valid TLS certificate has
not been installed, an Active Alarm is created and a message is displayed
stating that the system is in JITC Mode but Secured Communications Mode
is not enabled until the TLS certificate is installed.