Filter
Top Products
8-13
Chapter 8 SXYX
3-2 Moving arm type 2-axis model
For the moving arm type, an aluminum bracket is attached to the end of the
Y-axis. Install the tool on this bracket.
Twelve M6 coarse thread tap holes and two φ6 reamer holes are opened on the
bracket.
(Tap hole penetration)
3234
4429
50
15
12-M6×1.0 through hole
110(Tolerance between knock (0.02)
60
70 5
10
2-φ6H7 Depth6
35
100
10 (Plate thickness)17
Fig. 8-16 Moving arm type
!
CAUTION
If the fitting length is less than 9mm, the threads could be damaged during
tightening. If the length of the bolt screw is 27mm or more from the installation
surface, the screw could contact the Y-axis.
Select the minimum fixing bolt screw length so that the screw fitting length is
9mm or more.