Filter
Top Products
12-27
Chapter 12 HXYLX
5-5 Installing and removing the cover
5-5-1 Stroke cover
Removing the stroke cover
1) Remove the fixing screws (M4, pan-head) on both ends.
2) Place the table slide near the stroke end, and pull off the cover.
Center coverSide cover End blockMotor block
Table slide
Installing the stroke cover
1) Place the table slide near the stroke end, and pass the cover between the table
slide and motor block.
2) Fix the cover to the end block. At this time, move the table slide to the stroke
center, and confirm that it does not interfere with the cover. If the table slide
interferes with the cover, adjust by tightening the cover fixing screw. (Refer
to following photographs.)
When cover contacts table slide
⇒ Tighten the cover fixing screw
When cover contacts motor block
⇒ Loosen the cover fixing screw