Filter
Top Products
11-34
Chapter 11 FXYBX/SXYBX
4) Using a grease gun, replenish grease from the grease nipple installed on the
linear guide bearings.
Sufficient grease has been replenished when new grease starts to seep out
from the clearance between the linear guide bearings and rail.
FXYBX
X-axis, Y-axis
The X-axis has four bearings, and the Y-axis has two linear guide bearings.
Replenish grease to all bearings. Wipe off any excessive grease that has seeped
out to the rail.
Recommended grease gun : MG70 (THK) N-type nozzle
SXYBX
X-axis, Y-axis
The X-axis and Y-axis each have four linear guide bearings.Replenish grease to
all four bearings.
Wipe off any excessive grease that has seeped out to the rail.
Recommended grease gun : MG70 (THK) N-type nozzle
Z-axis (ZF)
One linear guide bearing is attached. A grease nipple is attached to the counter-
motor side of the slider, so move the slider to the motor side and then start the
work.
Recommended grease gun : MG70 (THK) H-type nozzle
5) Install the stroke cover.
Confirm the surrounding safety, and then turn the controller power ON.