Filter
Top Products
9-10
Chapter 9 MXYX
3-3 ZF
(Arm type, moving arm type, gantry type 3rd-axis option)
When using the 3rd-axis model with ZF for the 3rd-axis, install the workpiece
onto the ZF slider in the following manner.
Four M5 coarse thread tap holes and a φ5 reamer hole are opened on the slider's
workpiece installation surface. Install the tool using these holes. Four M5 coarse
thread tap holes are opened on the slider side. Use these as required to fix light
loads other than the tool, such as the wiring retainer.
Fig. 9-11 ZF
!
CAUTION
If the bolt fitting length is 12mm or more from the installation surface, the bolt
will contact the bottom.
Select the maximum nominal length of the tool fixing bolt so that the screw fit-
ting length is 12mm or less.
YAMAHA recommends a screw fitting length of 8mm or more.
2-φ5H7 Depth15
110
4-M5×0.8 Depth12
86
100
(Tolerance between knock (0.02)
70
9 9
50 18
10
4-M5×0.8 Depth9
Stroke cover
91