Filter
Top Products
11-21
Chapter 11 FXYBX/SXYBX
6 Installing the Cover
If the X-axis stroke is long, a slider mechanism is provided in the X-axis stroke
cover. The alignment of the slider and upper cover must be adjusted when install-
ing the cover.
Target FXYBX X stroke 2150mm or more
SXYBX X stroke 2450mm or more
!
CAUTION
If the slider and upper cover are not correctly adjusted, the slider could be
damaged prematurely.
When inserting into the U-character groove, take care not to cut the slider with
the edge of the cover.
1) Turn the controller power OFF.
2) Insert the slider into the U-character groove on the center of the upper cover.
Set the upper cover so that it is parallel with the axis movement direction at
this time.
Slider travel groove
Slider
3) Temporarily fasten the four upper cover installation screws, move the table
from the motor side to the counter-motor side end, and then completely tighten
the screws on the counter-motor side. Move the table to the motor side again,
and then completely tighten the two upper cover installation screws on the
motor side.
4) Move the slider by hand to check that it travels along the upper cover smoothly.