Filter
Top Products
11-30
Chapter 11 FXYBX/SXYBX
6) Attach the new belt.
7) First, lead the belt from the top of the idle pulley, and push it out with a
narrow rod, etc.
8) Next, lead the belt through the lower side of the slider and lead it to below the
drive pulley. Use a narrow rod, etc., to face the belt edge upwards.
9) Finally, mesh the belt between the drive pulley and drive pulley idler, and
turn the drive pulley.
10) Attach the belt stays to the belt.
11) Install the belt stays onto the slider table, and temporarily tighten the belt
stay installation bolts.
12) Refer to “Chapter 11 7. Adjusting the Timing Belt Tension”, and adjust the
belt tension.
13) Refer to “Chapter 11 6. Installing the Cover”, and install the upper cover.
14) Install the end cover.