Filter
Top Products
11-8
Chapter 11 FXYBX/SXYBX
Select the under head length of the bolt for fixing the tool so that the screw length
from the slider installation surface is 6mm or less.
!
CAUTION
If the screw length from the installation surface is 8mm or more, the screw
could interfere with the stroke cover.
NOTE
There is a step on the top of the slider. The actual tool installation surface is the
shaded section shown above.
3-2 SXYBX arm type 2-axis model
Eight M6 coarse thread tap holes and two φ6 reamer holes are opened on the
Y-axis slider.(Refer to Fig. 11-10.) Install the user tool onto the Y-axis slider
using these holes.
Four M5 coarse thread tap holes are also opened on the slider side. Use these as
required.
Fig. 11-10 SXYBX arm type
(Tolerance between knock (0.02)
8-M6×1.0 Depth16
32
70
134
2-φ6H7 Depth10
90
20 50
12.5
4-M5×0.8 penetration
(same on opposite surface)
12
12212