Filter
Top Products
132 DCS-100 • User’s Guide
_K==oÉãçíÉ=`çåíêçä
Remote Commands
oÉãçíÉ=`çãã~åÇë
This section lists DCS-100 remote commands, in the following categories:
• Ethernet Commands
• Input Commands
• Output Commands
• System Commands
• Key Commands
• LOGO Commands
bíÜÉêåÉí=`çãã~åÇë
ae`m
• Description: Enable/Disable DHCP mode
• Command Format: DHCP -m (mode)
• Command Params: -m mode: 0-disable, 1-enable (default: on)
• Query Format: DHCP -?
• Query Response: DHCP -m (mode) --min 0 --max 1
bj^`
• Description: Get MAC address
• Command Format: N/A
• Command Params: N/A
• Query Format: EMAC -?
• Query Response: EMAC -a (addr)
• Response Params: -a (addr): MAC address formatted xx.xx.xx.xx.xx.xx
d^qbt^v
• Description: Set gateway to be used when DHCP is OFF
• Command Format: GATEWAY -s (static addr)
• Command Params: s static addr: format will be: xxx.xxx.xxx.xxx
• Query Format: GATEWAY -?
• Query Response: GATEWAY -a (active addr) -s (static addr)
• Query Params: -a (active addr): Active gateway active address
fm
• Description: Set static IP address to be used when DHCP is OFF
• Command Format: IP -s (static)