Filter
Top Products
DCS-100 • User’s Guide 79
4. Operation
Using the Setup Menu
To clear the message and continue operations, press ESC.
aá~ÖåçëíáÅë
From the System Menu, select Diagnostics to display the Diagnostics Menu:
Figure 4-50. Diagnostics Menu
If you suspect a problem with the DCS-100, press SEL to run a series of internal diagnostic
tests. The menu will report back “PASS” or “FAIL.”
p~îÉ=póëíÉã=pí~íÉ
From the System Menu, select Save Config to save all current “system” settings so that
they may be restored at power up. A message is briefly shown, after which the DCS-100
returns to the System Menu.
Figure 4-51. Saving System Configuration Message
Please note the following important points regarding the system configuration file:
• When you perform the Save Config function, all configuration parameters from
the System Menu are saved in non-volatile memory. If you do not perform the
function, data will not be restored upon the next system power up sequence.
• This command also saves the current input as the default power-up selection.
Note
This message is a warning only, which does not prevent the
operation of the DCS-100. If this message appears, it is
recommended that you contact Barco Customer Service.
DIAGNOSTICS
> SEL = Start Tests
Note
If the menu reports “FAIL,” contact Barco Customer Service.
In Appendix C, refer to the “Contact Information
” section on
page 156 for contact details.
Saving System Config...
Note
If you want the DCS-100 to always power up and acquire an
input other than input 1, perform the Save System State
command while the desired input is selected on Program.