Filter
Top Products
DCS-100 • User’s Guide 87
4. Operation
Using the LOGO
• When you first start up a DCS-100 that has stored logos, a message like the one
in the following illustration appears during initialization:
Figure 4-60. LOGO Initialization Message (sample)
Ensure that you are familiar with the LOGO Setup Menu. Refer to the “LOGO Setup
Menu” section on page 67 for details.
p~îáåÖ=~=içÖç
Use the following steps to capture and store a logo:
1. To capture and store a full-screen logo, first select the input that you wish to store,
and transition it to Program with a TAKE.
2. From the Setup Menu, select LOGO Setup to display the LOGO Setup Menu.
Figure 4-61. LOGO Setup Menu (sample)
3. In the Selection field, press SEL and choose the “register” into which you want to
save the LOGO (e.g., LOGO1, LOGO2 or LOGO3). Press SEL again.
4. Scroll to the Save Pgm to Logo field, and press SEL to save the input as a full-
screen logo.
5. Repeat steps 1 through 4 to save up to two additional LOGOs.
qê~åëáíáçåáåÖ=íç=~=içÖç
To transition from the source on Program to a saved logo:
1. With an output source on Program, press the LOGO button. Please note:
LOGO1 loading...
5%
LOGO
LOGO SETUP
> Selection LOGO1
[EMPTY]
Save Pgm to Logo
Note
When a logo is pending or already on Program, the Save
Pgm to Logo field does not appear.
Important
When a “protected” HDCP source is selected (inputs 7 or 8),
and an HDCP compliant monitor is connected to the output,
you cannot save a LOGO.