Filter
Top Products
DCS-100 • User’s Guide 73
4. Operation
Using the Setup Menu
~ Select Set Static IP to display the Static IP Menu, which enables you to
set a static IP address when a DHCP server is not available. The editing
procedure is discussed below.
Figure 4-38. Static IP Menu (sample)
~ Select Set Netmask to display the Netmask Menu, which enables you
to set a netmask. The editing procedure is discussed below.
Figure 4-39. Netmask Menu (sample)
~ Select Set Gateway to display the Gateway Menu, which enables you to
set a gateway. The editing procedure is discussed below.
Figure 4-40. Gateway Menu (sample)
Use the following steps to edit the IP address, Netmask or Gateway. Valid
fields range from 000 to 255.
a. Press SEL to begin editing. This action highlights the first digit, and
displays the carat “^.”
b. Use the ADJUST knob to move the carat left and right through the
address.
c. When the desired digit is highlighted, press SEL to edit the value. The
carat changes to the pound sign “#.”
d. Use the ADJUST knob to select the desired value (0 - 9).
e. Once the value is selected, press SEL to “accept” the new value. The
pound sign “#” changes back to the carat “^.”
f. Repeat the process from step b for all additional digits that you wish to
change.
g. When complete, press ESC to display the Apply Changes Menu.
•Select Yes (SEL) to apply all changes.
•Select No (ESC) to exit the procedure without saving changes.
STATIC IP
> 192.168.000.001
Netmask
> 255.255.255.000
Gateway
> 192.168.000.002