Filter
Top Products
52 Administrator’s Guide SurfControl RiskFilter - E-mail V5.2.4
S
YSTEM
S
ETTINGS
User Management
2
END-USER CONTROL
Authorized users can log in to PEM with their own account and password, validated by a ‘User Validation’
connection and, depending on the settings in the Users List pane, can manage their own Black and White
lists. To use PEM, a User Validation connection with ‘Account Authentication’ must be set up for End-Users
to manage their own Black/White Lists.
Use the End User Control screen to set up End User Control.
Figure 2 - 32 The End-User Control screen
End-user Bypass Anti-Spam Setting
You can allow listed users to receive mail without an Anti-Spam check being run on them. If you have a
user who must receive all messages, regardless of type, then this will prevent important messages being
isolated as spam. It also can help where the type of mail a user receives results in a lot of false positives.
User List
You can specify users or lists of users then apply one of two conditions to them:
• Enable White List & Black List for all EXCEPT the address list below – Everyone EXCEPT the
users listed can manage their Black/White Lists.
• Enable White & Black List ONLY for the address list below – ONLY the users listed can manage
their Black/White Lists.
Setting up End User Control
To set up End User Control:
1Select User Management > End-User Control from the System Settings tab.
2Select Enable end-users to bypass Anti-Spam checking.
3 Decide who you want to apply the settings to and select the option that matches the way you want to
apply the setting (see above).
4In the Enter user e-mail address: field enter a domain or e-mail addresses in one of the following
ways:
• Enter the e-mail addresses of all users that you want to apply the settings to, e.g.
user@mydomain.com
• Enter *@ followed by the domain – all users in that domain will be included in the list.