Lincoln Electric SVM200-A Welder User Manual


 
INSTALLATION
A-4 A-4
VRTEX
TM
360
TILTING
Place the VRTEX
TM
360 directly on a secure, level sur-
face.
HIGH FREQUENCY INTERFERENCE PRO-
TECTION
READ ENTIRE INSTALLATION SECTION BEFORE
STARTING INSTALLATION.
Safety Precautions
------------------------------------------------------------
SELECT SUITABLE LOCATION
The machine will not operate in harsh environments. It
is important that simple preventative measures are fol-
lowed in order to assure long life and reliable opera-
tion. This product is for INDOOR USE ONLY.
• Dirt and dust that can be drawn into the machine
should be kept to a minimum. Failure to observe
these precautions can result in excessive operating
temperatures and nuisance shutdown.
• Do not locate where monitor is exposed to direct sun-
light.
• Do not place equipment near radiant heat sources.
• Do not place in a confined space. Allow a minimum
of 3 feet of clearance around machine at all times.
Adequate ventilation is necessary.
• The circuit breaker switch on the rear panel is the
input power disconnect device. Do not position the
equipment so that it is difficult to operate the circuit
breaker.
• Route and protect power cable to minimize exposure
to damage.
ENVIRONMENTAL AREA
Keep the machine inside and dry at all times. Do not
place it on wet ground or in puddles. Never place liq-
uids on top of the machine.
STACKING
The VRTEX
TM
360 cannot be stacked.
ELECTRIC SHOCK can kill.
Only qualified personnel should per-
form this installation.
• Turn the input power OFF and unplug
the machine from the receptacle
before working on this equipment.
Insulate yourself from the work and ground.
• Always connect the
VRTEX
TM
360
to a power sup-
ply grounded according to the National Electrical
Code and local codes.
WARNING
CAUTION
USE CAUTION WHEN OPERATING THIS MACHINE
AROUND OTHER EQUIPMENT.
Large equipment, such as cranes, may interfere
with the operation of this machine.
• This machine may interfere with the operation of
other equipment in work/training area.
• Lift only with equipment of ade-
quate lifting capacity.
• Be sure machine is stable when
lifting.
• Do not operate machine while
suspended or when lifting.
FALLING EQUIPMENT can cause injury.
------------------------------------------------------------------------
WARNING
LIFTING
If lifting the
VRTEX
TM
360
is required, use two straps, each
rated for 500 pounds or more. Do not attempt to lift the
VRTEX
TM
360
with accessories attached to it.
STRAPS
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC