Filter
Top Products
FIGURE F.42 – STRAIN RELIEF
VR SMAW (STICK) DEVICE
REMOVAL AND REPLACEMENT PROCEDURE (continued)
REPLACEMENT PROCEDURE
1. Install the new VR SMAW Device by replacing
the two screws securing the sheet metal strain
relief to the front panel.
2. Connect plug J3 to the relay board.
3. Reconnect the 16 pin molex cable splice.
4. Turn on input power.
5. Perform Case Cover Replacement
Procedure.
6. Perform the Monitor and Pedestal
Replacement Procedure.
7. See the Retest After Repair.
TROUBLESHOOTING AND REPAIR
F-91 F-91
VRTEX
TM
360
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC