Filter
Top Products
PLUG J37
(VIEWED FROM REAR)
FIGURE F.38 – DISPLAY LED BOARD PLUG LOCATION
DISPLAY BOARD
REMOVAL AND REPLACEMENT PROCEDURE (continued)
REPLACEMENT PROCEDURE
1. Install the new Display Board onto the three
mounting stand-offs.
2. Replace plug J37 previously removed from the
Display Board.
3. Close the control panel.
4. Install the two 3/8” screws previously removed
from the top of the control panel.
5. Turn on input power.
6. See the Retest After Repair.
TROUBLESHOOTING AND REPAIR
F-83 F-83
VRTEX
TM
360
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC