Filter
Top Products
FIGURE F.13 – VGA & POWER CORD LOCATION
MONITOR AND PEDESTAL REMOVAL AND REPLACEMENT PROCEDURE
(continued)
REMOVAL PROCEDURE
1. Remove input power.
2. Disconnect the power supply cord and VGA
(blue) input cable from monitor. See Figure
F.13.
3. Using a phillips screwdriver, remove two bottom
monitor mounting screws. See Figure F.13.
4. Loosen the top two phillips screws and carefully
separate monitor from pedestal.
Note: It is not necessary to completely remove the
top two phillips screws unless a new monitor
is required.
5. The monitor can now be removed.
Note: It is not necessary to remove the pedestal if
just the monitor is to be replaced
6. Using a 7/16” wrench, remove the monitor
pedestal mounting screws. Note washer place-
ment upon removal. See Figure F.14.
7. Remove pedestal.
TROUBLESHOOTING AND REPAIR
F-40 F-40
VRTEX
TM
360
Power Cord
VGA
Phillips Screws (4)
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC