Filter
Top Products
INTERFACE MODULE
DIGITAL I/O
HORIZONTAL
MOUNTING
SHELF
INTERFACE MODULE (USB)
FIGURE F.33 – INTERFACE MODULE (USB) LOCATION
INTERFACE MODULE (USB)
REMOVAL AND REPLACEMENT PROCEDURE (continued)
REMOVAL PROCEDURE
1. Remove input power.
2. Perform the Monitor and Pedestal Removal
Procedure.
3. Perform the Case Cover Removal Procedure.
4. Locate the Interface Module (USB). See Figure
F.33.
5. Label and disconnect the USB cable. See
Figure F.34.
6. Unplug the 16-pin terminal strip from the
Interface Module (USB). See Figure F.34.
7. Carefully remove the Interface Module (USB)
from the top of the interface module digital I/O.
NOTE: The Interface Module (USB) is secured to
the interface module digital I/O with Hook &
Loop mounting pads.
TROUBLESHOOTING AND REPAIR
F-76 F-76
VRTEX
TM
360
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC