Filter
Top Products
FIGURE F.35 – SHORTCUT TO START-UP SIM SCREEN SHOT
INTERFACE MODULE DIGITAL (USB)
REMOVAL AND REPLACEMENT PROCEDURE (continued)
11. Click on the following in order:
• Start
• All Programs
• National Instruments
• Measurement and Automation
See Figure F.36
• Devices and Interfaces (click “+”)
• USB Devices
• Tools
• NI-Visa
• Visa Options
• Aliases
• Clear all Aliases
• OK
• Close out Screen
• YES (to save)
12. At this point, a basic computer screen desktop
will appear.
13. Click on the following in order:
• Start
• All Programs
• National Instruments
• Measurement and Automation
• Devices and Interfaces (click “+”)
• USB Devices (click “+”)
• USB 0……………….
14. In the box labeled “Visa Alias” on my system,
type these letters: LECSPI (in CAPS)
15. Save and close out screen.
16. Shut down the VRTEX
TM
360 via a normal CPU
shutdown. Click:
• Start
• Turn off computer
• Turn off
17. Remove input power after CPU has complete-
ly shut down.
18. Disconnect the USB keyboard and mouse.
19. Perform Case Cover Replacement
Procedure.
20. Perform the Monitor and Pedestal
Replacement Procedure.
21. See Retest After Repair.
TROUBLESHOOTING AND REPAIR
F-78 F-78
VRTEX
TM
360
Return to Section TOC Return to Section TOC Return to Section TOC Return to Section TOC
Return to Master TOC Return to Master TOC Return to Master TOC Return to Master TOC