Filter
Top Products
DR4300 Circular Chart Recorder
78 DR4300 Circular Chart Recorder Product Manual 12/03
4.3.4 Configuration Tips
Introduction
Table 4-2 contains tips that will help you enter the configuration data more quickly. If you can not change
configuration parameters, check the status of the “LOCK” parameter (see Subsection 4.3.19).
Table 4-2 Configuration Tips
Function Tip
Displaying Groups
Use the SET UP key to display the set up groups. The group titles are
listed in this section in the order that they appear in the recorder.
Displaying Functions
Use the FUNC
key to display the individual function parameters under
each group. The prompts are listed in the order of their appearance in each
group.
Scrolling
Holding the SET UP key in will scroll through the set up groups. However,
when any set up group is displayed, you can scroll through the set up groups
twice as fast using the ▲ or ▼ key. When in any set up group, hold the
FUNC key in to scroll through the prompts within that group.
Changing values quickly
When changing the value of a parameter, you can adjust a more significant
digit in the upper display by holding in one key [▲] or [▼], and pressing the
other [▲] or [▼] at the same time.
• The adjustment will move one digit to the left.
• Press the key again and you will move one more digit to the left.
Exiting Set Up mode
To exit Set Up mode, press the DISP key.
This returns the display to the same state it was in immediately preceding
entry into the Set Up mode.
Timing out from
Set Up mode
If you are in Set Up (configuration) mode and do not press any keys for one
minute, the recorder will time out and revert to the mode and display that was
being used prior to entry into Set Up mode.