Filter
Top Products
Installation of Spray ECU 30S KEE Sprayer Kits
Installation
of
a
Shaft/Speed
Sensor
kit
to
a
tail
shaft
1. On a tray mounted sprayer the Shaft/Speed Sensor Kit can used to read from the
vehicle tail-shaft. Refer to Figure 9. Using the Hose Clamp or other suitable means
securely mount the Magnet Block on the flange between the transmission housing and
the tail shaft. Note: Do not attach the Magnet Block directly to the tail shaft as its
position changes through its rotation. The Wheel Stud Magnets are not used in this
case.
2. Using an existing bolt on the transmission housing and the supplied Mounting Brackets
or other suitable means, securely mount the Shaft/Speed Sensor so it squarely faces the
Magnet Block with a clearance of 2 to 3mm (1/16 to 1/8 inch).
3. Ensure that the Shaft/Speed Sensor is firmly attached and protected so that it cannot
be damaged by wire or stones. If necessary cover the Shaft/Speed Sensor with a plate.
4. Use the 3-pin Weather Pack Extension provided if required, connecting the Shaft/Speed
Sensor to the Ground Speed connector on the Tractor Harness or Sprayer Harness.
Using
an
existing
radar
speed
sensor
for
ground
speed
1. An optional Radar Sensor Interface Harness (A449 - not provided as part of this kit but
may be ordered separately) allows direct connection to any existing radar speed sensor
on the tractor.
2. Connect the Radar Sensor Interface Harness to the Ground Speed connector on the
Sprayer Harness or Tractor Harness then connect this wire to the signal wire from the
radar sensor (not provided) to enable the Spray ECU to read the speed. Note: Check
the radar sensor manufacturer's manual before attempting connection. Use the
Extension Harness provided if required connecting the radar sensor to the Ground
Speed connector on either the Sprayer Harness or Tractor Harness.
Page 18
V1.98 21/06/06
Figure 9 : Shaft/Sensor Sensor installation a tail shaft