Filter
Top Products
Major Topic Heading
Setup Options-ECU
Speed
From
Select from one of the 3 options; ‘Wheel Sensor’, ‘Tractor Radar’ or ‘GPS Speed’. Depending
on whether ‘Spray Interface’ or ‘Spray ECU’ was selected in the ‘Controller’ options.
‘‘SSpprraayy
IInntteerrffaaccee’’
1- Select ‘Wheel Sensor’ if a ground speed sensor is connected to the spray harness plug
marked ‘Wheel Sensor’, usually located on the ‘Spray Harness’.
2- Select ‘Tractor Radar’ if connecting a Tractor Radar to the ‘Spray Interface’. The Tractor
Radar plugs into the ‘3 pin weather pak’ plug marked ‘Tractor Radar’, on the
‘Spray Interface’.
3- Select GPS if the speed is from a DGPS receiver. ZYNX Guidance has to be loaded and
selected from the ‘ZYNX Product Selection Screen’, in conjunction with the ZYNX Spray Rate
control, for GPS Speed to be selected.
‘‘SSpprraayy
EECCUU’’
1- Select ‘Wheel Sensor’ if a ground speed sensor is connected to the ‘spray harness’ plug
marked ‘Connector 1’ on the ‘Spray ECU’, the wheel sensor is usually located on the boom
spray.
2- The
‘‘RRaavveenn’’
‘Spray ECU 3’ and ‘Spray ECU /SR’ has a 3 pin Plug marked Radar on the ‘Spray
ECU 3’, if a Radar is connected to this plug then select ‘Tractor Radar’.
3- Select GPS if the speed is from a DGPS receiver. ZYNX Guidance software has to be loaded
and selected from the ‘Product Selection Screen’, in conjunction with the ZYNX Spray Rate
control, for GPS Speed to be selected.
Page 49
V1.98 21/06/06