Filter
Top Products
Navigating Around the Options Window
SSeelleeccttiioonn
OOppttiioonnss-
Are options identified with white circles lying next to the written option.
Examples of ‘Selection Options’ are ‘Tank 1 Mode’, ‘Lines’, and ‘Controller’ windows. With
‘Selection Options’ for that window,
oonnee
and
oonnllyy
oonnee
option can be selected. The option is
selected when a black ‘dot’ is placed in the circle next to it. At
lleeaasstt
oonnee
of the options must
be selected. Example the ‘Lines’ window; in this window you can select either ‘Single’ or
‘Dual’; one of the options must to be selected. If ‘Single’ was already selected, but your system
was a ‘Dual’ line system, then you would select ‘Dual’ by touching the screen where ‘Dual’ is
written. A black ‘dot’ would be placed next to ‘Dual’ and the black ‘dot’ next to ‘Single’ would
disappear.
BBuuttttoonnss-
The rectangular ‘Buttons’ on the screen allow the operator to access extra options.
Examples of ‘Buttons’ are: ‘DONE’, ‘Settings’ , ‘Calculator Icon’ and ‘Enable Diagnostics’. When
the ‘Calculator Icon’ is selected, this displays screen keyboard for entering values into. The
‘DONE’ button closes the ‘Options’ window. The other buttons on the screen usually open up
other windows to allow the operator to select options.
UUpp
aanndd
DDoowwnn
AArrrroowwss-
Next to some ‘Display Windows’ there are up and down arrows to alter
the current value, without using the ‘Calculator Icon’ button. Usually a ‘mouse’ is required to
use the up and down arrows.
The ‘UP’ arrow increases the value displayed in the ‘Display Window’.
The ‘DOWN’ arrow decreases the value displayed in the ‘Display Window’
IInnaaccc
ceessssiibbllee
OOppttiioonnss-
When a ‘window’ is greyed out this means that ‘window’ is inaccessible.
In the example (see page 33) the ‘Controller 1’ window is greyed out because the ‘Controller’
selected on the ‘ECU’ page is not capable of controlling proportional valves, therefore the
‘window’ is locked on the ‘Regulator Valve’ option. When a different ‘Controller’ i.e ‘Spray
ECU 2’ is selected then the ‘Controller 1’ window will become accessible.
DDiissppllaayy
WWiinnddooww-
Displays the current value, which is next to the option.
SSiimmuullaattiioonn
mmooddee-
If ‘Simulation mode’ is displayed, in RED on the ECU page then ‘Simulation’
has been selected from the ‘Com Port’ window. This is useful if the X20 Console is being setup
and not connected to a Spray ECU. When in ‘Simulation mode’ it stops all alarms from being
displayed.
OOppttiioonnss
WWiinnddooww-
The Options window cannot be resized. The Options window cannot be
minimised or maximised.
Page 40
V1.98 21/06/06