Filter
Top Products
Sprayer Software Setup -GPS
4.0 GPS
Note: the GPS Page is only displayed when Guidance and OR ‘Variable Rate Control’ (VRC) is
selected with ‘Spray Rate Control’, when selected from the ‘ZYNX X20 Product’ screen .
Otherwise the ECU page will be the first page.
Auto
Section
Control
(ASC)
‘‘AAuuttoo SSeeccttiioonn’’
can only be selected when a DGPS is used in conjunction with ZYNX Guidance.
This feature will automatically switch sections on the sprayer, ON and OFF, therefore
preventing the sprayer from overlapping or under lapping previously sprayed areas. The ASC
option in ZYNX Guidance, ‘General Setup’ must also be selected.
To use ASC select the ‘Enabled’ option.
Otherwise select ‘Off’
VVRRCC//LLooggggiinngg
MMooddee
Select ‘Off’ if not using VRC or Logging.
Note: When ‘Logging Only’ and ‘VRC and Logging’ are selected then the ‘VRC/Logging
Synchronization’ window will be displayed. The only difference between ‘Logging Only’ and
‘VRC and Logging’, is when ‘Logging Only’ is selected the ‘VRC Master’ button is removed
from the Guidance screen, to prevent confusion. When selecting ‘Logging Only’ and ‘VRC and
Logging; ‘Variable Rate Control’ (Maplink VRC) must be selected in the ZYNX Product
Selection screens during Startup.
Select ‘Logging Only’ if
nnoott
loading a VRC prescription map but logging the sprayrates or
elevation mapping using the Maplink VRC software. This allows logging to be done without
loading a VRC prescription map.
Select ‘VRC and Logging’ if using the Maplink VRC software, to load a VRC prescription map
to control the sprayrates to a region based map. A ‘VRC Master’ button will be displayed on
the Guidance and Maplink VRC screens.
Page 46
V1.98 21/06/06
FFiigguurree
2288::
OOppttiioonnss-
GGPPSS
ppaaggee