Filter
Top Products
How to use this Manual
8. Section 16: ‘Saving the Configurations’ section shows the operator how to save and
name the sprayer settings entered into the Sprayer Software Setup (Sections 4 to 15).
9. Section 17:’Setting up the Sprayer’ explains the Pressure, Flow, Speed, and
Area/Volume windows. This section explains how to ‘Fill the Tank’ and the Sprayer
Switchbox. This section also explains how to Calibrate the Pressure Sensor and Flow
sensor. Setting up is now complete the sprayer is ready for testing.
10. Section 18: ‘Start Spraying’ section explains how to test and simulate spraying using
water before any actual spraying takes place. The section then explains how to start
spraying, in either MANUAL or AUTOMATIC mode.
11. Section 19: The ‘Testing’ section explains how to test the Regulator Valve, test for
Switch power for the Spray ECU, test the dump valve, test KEE sensors, test for 3 wire
section valves and test PWM valves.
12. Section 21: The ‘Wiring Connection Tables’ section shows how to select between
‘Spray Rate Interface’ and ‘Spray ECU’ controllers when selecting in the software.
This section also contains the Wiring Connection tables for each of the connectors for
the different Spray ECU’s.
13. Section 22: This section contains the schematic wiring diagrams of the current the KEE
Spray ECU 30S Tractor and Sprayer harness’s available.
Page 8
V1.98 21/06/06