Filter
Top Products
Start Spraying -Using ZYNX Guidance with the Spray Rate Controller
.
Page 98
V1.98 21/06/06
With Automatic Section Control (ASC) activated, the sprayer will automatically switch the
boom sections ON/OFF as required by the coverage map.
For the ASC to work the ‘Auto Section Enabled’ option has to be enabled in OPTIONS/GPS
page, in the ZYNX Sprayer software. When ‘Auto Section Enabled’ has been selected then
the ‘ASC Master’ button will appear on the ‘ZYNX Logo’ bar, on the ZYNX Guidance
screen. The ‘ASC Master’ button will not function unless, the ASC also has to be enabled
in the General Setup/Auto Section Control in the ZYNX Guidance software.
When the ‘ASC Master’ button is ‘green’ then the ASC control will control sections ON or
OFF as required.
When the ‘ASC Master’ button is ‘red’ then the ASC control will be
ddiissaabblleedd
and the
switching OFF and ON of sections will be performed by the operator.
Therefore the ASC can be left enabled in the ZYNX Guidance, General Setup/Auto Section
Control and the ASC can be enabled or disabled from the ZYNX Guidance screen by
selecting the ‘ASC Master’ button.
Note: the sections being switched
OOFFFF
when the boom section is fully over an area already
mapped ( Applied ). The sections also switch
OONN
so that there is no untreated areas left.
‘ASC Master’ Button
FFiigguurree
6666::
ZZYYNNXX
GGuuiiddaannccee
sshhoowwiinngg
AASSCC
MMaasstteerr
bbuuttttoonn