Filter
Top Products
Start Spraying
18.2 START SPRAYING
Switch the ZYNX Console ON.
Make sure ‘Sprayer Controller’ is selected on the ‘Product Selection Screen’.
Start pump and bring to operating pressure.
Check the Preset Rates and Rate Increment are set correctly for the spray job. (If spraying in
AUTO mode.)
Select a Sub-Area Number and reset if necessary.
Fill or Set a Volume for the tank.
If using more than one tank, make sure the ‘Tank X is ON’ is switched ON for each tank. The
‘Tank Icon’ will be an orange colour if the tanks are ON and a volume entered into the ZYNX
Console.
SSPPRRAAYYIINNGG
IINN
MMAANNUUAALL
MMOODDEE
Select ‘MANUAL’ button if spraying in manual, the button will be highlighted and the green
indicator, on the ‘MANUAL’ BUTTON will be displayed.
Press the increase and decrease buttons to set the pressure.
Switch the Master Switch ON and drive to the set speed and pressure for the nozzle selection,
using the increase and decrease buttons to set the pressure.
SSPPRRAAYYIINNGG
IINN
AAUUTTOO
MMOODDEE
Select ‘AUTO’ if spraying in AUTO mode. The ‘MANUAL’ button will still be highlighted but
the indicator light on the ‘MANUAL’ button will be red; indicating the ZYNX sprayer has the
‘AUTO’ mode selected but isn’t spraying in AUTO mode yet.
Select the ‘Master Switch’
If a ‘Low Speed Shutoff’ is selected then the boom sections will be red and are not spraying.
Once the sprayer takes off the ‘Speed Readout’ will display the current speed, when the speed
goes above the ‘Low Speed Shutoff’ value the boom sections turn green and start spraying in
manual mode. The indicator on the ‘MANUAL’ button is still red and the application rate will
be displayed but showing a white background; these both indicate the sprayer is spraying in
manual mode. This will happen if a ‘Low Speed Shutoff’ value has not been reached.
Once the speed increases and the speed goes above the ‘Low Speed Shutoff’ value then the
‘AUTO’ button will become highlighted and the green indicator will be shown on the ‘AUTO’
button, and the application rate will have an orange background when the rate has been
achieved.
The sprayer is now spraying in AUTO mode.
WWHHIILLEE
SSPPRRAAYYIINNGG
While spraying the speed will be displayed.
Area and Volume will start accumulating.
Pressure will be displayed if selected.
Either Volume/Minute or Volume/ Nozzle will be displayed.
The Volume remaining on the ‘Tank Icon’ will start counting down.
The current application rate will be displayed.
Any alarms that arise will be displayed.
Once the ‘Tank Icon’ turns to red, the ‘Low Volume’ point has been reached, alerting the
operator the tank, has reached the ‘low point’ alarm.
When the ‘Master Switch’ is OFF it turns red; when the ‘Master Switch’ is ON it turns green.
Page 96
V1.98 21/06/06