Filter
Top Products
STE 58760
－ －
2-6
Note 1)
Should the "POWER LED" on the control panel not light even if the MAIN POWER switch is
turned on, or should any fault occur in the system, immediately turn off the Main Power switch
and check the cables connected to the controller.
Note 2)
If the system disk was in the FDD unit when the main power was turned on, the controller will
perform cold start. Before turning on the main power, check to see that the system disk has not
been inserted into the FDD unit.
Note 3)
If a floppy disk which contains any of the files CONSTRUC. SYS, SYSTEM. PAR, USER. PAR,
EXTRNSEL. SYS, SCOL. LIB, ALARM.MES, or AUTOSTR. BAT has been inserted into the
FDD unit, the contents of the files will be read to the controller when the main power is turned
on. For an outline of each file, see Chapter 5.
(2) The controller starts up.
When the controller has been correctly started up, the following message appears on the LCD
display on the teach pendant
>
■
EDIT LOAD SAVE TESTRUN> RESET NEXT
F1 F2 F3 F4 F5 F6