Filter
Top Products
STE 58760
－ －
2-7
During hot start-up, the controller works as follows: When the main power is turned on, the
controller reads in the contents of the floppy disk in the FDD. Unless the system disk has not
been inserted, the system stored in the controller conducts hot starting. During the hot start
operation, the lamp on the "START" switch on the control panel blinks. When the controller is
started up, all the lamps on the "START", "STOP" and "CYCLE STOP" switches light for approx.
0.5 sec. After that, the lamp on the "STOP" switch lights and the screen as shown above
appears. After that, files for parameters and so forth are read in from the floppy disk to the
controller. Any required files are read to the controller.
After all the files have been read, the automatic execution file is executed. In this state, the
controller can be operated.
For details of the automatic execution file, see 3.5, "Batch Processing".
If an error occurs during the hot start operation, take proper action corresponding to the error
message which appears on the display. If the controller cannot be started up using the hot
start operation, conduct the cold start.
The hot start operation is now complete.